Wifi IP mpeg4 cam 54 mbps

Wifi IP mpeg4 cam 54 mbps

WL-401 v1 001

Back

My Wi-Fi Home Cam cannot see my home network. What now?

My Wi-Fi Home Cam cannot see my home network. What now?

Temporarily place the Wi-Fi Home Cam close to the modem/router you are trying to connect to, just for the installation. Wait until it appears in the list of available Wi-Fi networks.

Something else you can try is to set the modem/router to a different Wi-Fi channel. Check the manual for your modem/router to learn how. There may be less interference on the new channel, in which case the Wi-Fi Home Cam may now be able to find your home network.

Did this work? Then reset the Home Cam. You can do this by holding the reset button for 3-5 seconds. This is shown below.

Home Cam Twist reset button   Home Cam Mini reset button

 

                Wait until the Home Cam has rebooted. The LED is now a steady purple.

                Now perform the installation again (see manual).

If you still do not see your home network in the list of available Wi-Fi networks, temporarily place the Home Cam closer to the modem/router you are trying to connect to.

            Reboot your modem/router.

This can also be a useful way to resolve various Wi-Fi problems. You can do this by disconnecting the power cable from your modem/router and then plugging it in again after ten seconds. Wait a few minutes until the modem/router has restarted.

Please also note: The Wi-Fi Home Cam does not support 5GHz. So make sure you connect to the 2.4GHz network.

Rate this anwer. This answer is:

Good, it was clear
Not good, it was not clear

More information

See other FAQs ›